SE
AND A
TO REPLACE HEADLIGHT BULB
• Raise hood_
° Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb hoIder securefy
back into the hole in the backside of the gritt,
. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or' prevent it from starting.
° Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder' is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 28)
° Raise hood.
• Unsnap headlight wire connector.
• Stand infront oftractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
• To replace, reverse above procedures°
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 28
22
