ASSEMBL Y
CAP
112 'o HEX LOCKNUT
2 - 1t4" DfA WASHER
STEER;NG WHEEL
FIGURE 3
WHEEL _NSERT
STEERtNG COLUMN
AiR _ '.-_r""_-.
FIGURE 4 COMPARTMENT
3, Install Steering Wheel
4,
NOTE; POSITION FRONT WHEEL FORWARD,
a Use a 3/4" wrench to remove hex nut, end
2 - 1/4"" diameter washer {shown full size below)
from steering column (Fig, 3j,
b Position steering wheel over steering wheel
insert,
c Secure steering wheel to steering column using
2,1/4" diameter washer and hex nut lFigo 3),,
Torque to 50 ft - lbs_
d.. Snap steering whee! cap in place on steering
wheel Steering wheel cap found in bag of parts..
[
Check Tires
Reduce tire pressure to 14 PS/ in front tires and
12 PSi in rear tires, (Tires were over inflated for
shipping purposes}°
Install Batter),
DO NOT SHORT BATTERY TERMINALS,
BEFORE INSTALLING REMOVE
BATTERY,
METAL BRACELETS, WRISTWATCH BANDS,
RINGS, ETC.
a, Lift hood from rearside; (Fig. 4).
b. Lift out air lntake duct.
c. Make sure drain tube (Fig, 5) is fastened to drain
hole in battery tray and battery tray is posi-
tioned in hole of battery support.
d, Place battery in plastic tray (battery terminals
to front of trector) (Fig. 5),
POSITIVE TERMINAL MUST BE CONNEC.
TED FIRST TO PREVENT SPARKS FROM
ACCIDENTAL GROUNDING.
FIGURE 4A 8
