SSD SATA 5000 2.5" Product Manual
Rev 0.7
© 2008 SanDisk® Corporation 18 July 2008, Document No. 80-11-01488
8.1 Troubleshooting
8.2 Basic Checks
Most disk problems are caused by improper disk installation. If a problem
arises, the following should be checked:
Cable:
o Improper cable has been used
o Cables are too long to support the transfer rate
o Improper cable connection to the device
Device connector: Improperly locked
Power supply: Below SSD requirements
8.3 BIOS Setup
Verify that the disk is enabled in the BIOS. In most new BIOSs, there is
an option for drive auto-identification.
8.4 Slow Drive Performance
Poor disk performance may be due to one of the following:
Check that Write Caching is enabled in the drive under the category
Properties.
