Switching to Single Mode
In a split mode, select and double-click a desired channel to switch to its Single mode.
Press the number corresponding to a desired channel on the front panel or the remote control to switch to its
Single mode.
Refer to “Remote Control>Using the numeric buttons”. (Page 12)
Ex : If double-clicking CH 3 or pressing the number “3” on the remote control or the front panel.
SPOT OUT
The SPOT OUT monitoring is independent of the Live mode, which monitors a specifi c channel through the SPOT
OUT port.
Selecting a SPOT OUT mode
If an event occurs such as sensor, motion or alarm from the SPOT OUT port in connection with a monitor, you
can select a output screen mode.
In Live mode, right-click any area on the screen.
The Live menu appears.
Click SPOT OUT.
The split screen appears according to the SPOT OUT
source. (Page 47)
SPOT OUT 1 : Supports 16-, 9-, 4-split, Auto Sequence and
Single modes.
SPOT OUT 2, 3, 4 : Supports 4-split, Auto Sequence and Single
modes.
For the SPOT OUT port of a model, refer to “Part Names and
Functions (Rear)”. (Page 10)
`
1.
2.
`
`
`
