COLOR CCD CAMERA User Guide
12
COLOR CCD CAMERA User Guide
13
•
Coaxial Communications System
•
OSD Control method
1. Please take off the CCD protection cap
and C-mount adaptor.
C-mountadaptor
CCDprotectioncap
CS-mountadaptor
When using a CS-Mount lens
•Pleaseusethespecifiedlensconnectionpartsasshowninthepicturebelow.
Theuseofthewrongsizedpartsmaycausedamagetotheinsideofthecameraor
result in poor fitting.
•Useofalenswhichistooheavyaffectsthebalanceofthe
cameraandmaycauseamalfunction.Pleaseusealens
thatweighslessthan450g.
•PleaseselectAvmodeifpossiblewhenadjustingthe
automaticlightcontrol(ALC)ofanautolens.UseofPK
mode may cause hunting.
Notes
C-mountlens:10mmorless
CS-mountlens:5mmorless
2. Please attach the CS-Mount lens to the
camera by screwing it in clockwise.
Installation
Connecting to the Monitor
Please connect the video output terminal located on the back of the camera to the monitor.
CCDCamera Monitor
•Theconnectionmethodvariesdependingonthetypeofmonitorandaccessories.Please
refer to the user's manual for each instrument.
•Pleaseturnoffthepowerwhenconnecting.
•
Please select Hi-Z on the 75Ω/Hi-Z switch for the intermediate video TV set and select 75Ω
for the Intermediate device as shown in the picture below.
CCDCamera
Intermediate Endmonitor
Using Coaxial Communications
Distance
Recommended Cable Specification
300m 3C2V(RG-59/U)
450m 5C2V(RG-6/U)
600m 7C2V(RG-11/U)
• Video Cable
The camera's video output port is connected to the monitor with a BNC coaxial cable,
shown below : If the distance between the camera and the monitor exceeds the
recommended maximum, please use an auxiliary video amp.
•Itisrecommendedthatpurecoppercoaxcableisusedandnotcoppercoatedsteel,as
this will cause issues with the communication over the coaxial cable.
Notes
CAMERA DVR CONTROLLER
SET MENU/ENTER OSD KEY
UP UP KEY JOYSTICK UP
DOWN DOWN KEY JOYSTICK DOWN
LEFT LEFT KEY JOYSTICK LEFT
RIGHT RIGHT KEY JOYSTICK RIGHT
DVR
•
:BNC
•
----:RS-485