System Requirements
4 5
1
Turn OFF your computer. Remember to verify the
configuration jumper on the rear of the CD-ROM drive.
2
Remove the cover of your PC. (main unit of the computer)
3
Remove the blank cover panel of the 5.25 inch unit in
which the CD-ROM drive is to be installed.
6
Put the cover back on your PC.
5
Install the CD-ROM drive into the unit and secure it with
mounting screws. (recommended standard M3x6x4)
☛
◆
Depending on your PC model, you may need to
attach guide rails to the drive, so that the drive is
held firmly in place.
☛
◆
If you use screws that are longer than the
recommended standard, you may damage the
drive.
Before you install the CD-ROM drive, we strongly recommend that you make certain
that your set-up meets the system requirements listed below.
Installing the CD-ROM Drive
Install the CD-ROM drive in your computer horizontally, making sure that the Open/Close
button is on the right.
To install the drive, proceed as follows.
4
Connect the CD-ROM drive to the IDE interface and power
cables Iocated inside your computer.
☛ Connectors are keyed so it is impossible to put them in
an incorrect position. Do not force the connectors, if they
do not seem to fit.
Item
Windows version
MS-DOS version
Disk space
Free expansion unit
Type of computer
Description
3.1(or higher)
5.0(or higher)
100KB minimum
5.25 inch
IBM 486SX 20MHz (or higher) with
an IDE interface(or a 100% IBM-
compatible computer)
Installing the Software
You can install the device driver for DOS or for Windows.
¡ Do not install DOS Driver when the program of Windows 95/98 is going on.
(Remark CD-ROM Driver in the state of CONFIG. SYS.)
1
Turn on your computer and wait for it to boot.
2
Insert the driver disk into a floppy disk drive(usually the A drive).
3
If you are a...
DOS user
Windows user
Windows 95/98 user
Then :
◆ Type a: at the DOS prompt
◆ Press the RETURN key
◆ Access the File Manager
◆ Click on the A icon.
◆
Type CDSETUP after the A: prompt
◆ Press RETURN
Double-click CDSETUP.EXE from the Windows
File Manager
◆ When you are in Windows 95/98, it is not
◆ necessary to install Device Driver.
◆ Whereas, when you are in Dos Mode of
◆ Windows 95/98, then install as follows.
◆ Click on MY COMPUTER icon.
◆ Click on the A icon.
4
5
6
Run the CDSETUP program:
To...
Confirm the installation Y
Exit without installing N
When the Setup Completed screen is displayed, remove the installation
floppy disk from the drive.
7
Reboot your system.
If you answer Y(Yes), the installation program automatically
◆ Creates a SAMSUNG directory on your hard disk
◆ Copies the required softwares (mscdex.exe and sscdrom.sys)
◆ Modifies the CONFIG.SYS and AUTOEXEC.BAT files
Result :
◆
The computer restarts
◆
Both the device driver and MSCDEX are loaded
Result :
Then enter...
If you are a...
Then :
DOS user
Windows user
