EVALUATION BOARD MANUAL S3F401F_BD_UM_REV1.00
3
1.1 FEATURES
Micro-Controller S3F401F, ARM7TDMIS, 16/32-bit RISC Microcontroller
External DC 7~12V Board Power Source
Adjustable voltage regulator out is 3.2V
Board Master Power Switch SW6
Support to protocol for RS-232
Physical interface circuit connected to standard PC through DB9(female)
UART
Interface driver IC MAX3221
Provide SSP, SPI serial communication with external devices (master or slave)
SSP serial EEPROM (8K * 8bit): X25650
Synchronous Serial Port
SSP serial EEPROM (4K * 16bit): 64LC40S
LED IO Port output control display
JTAG Connection 20Way JTAG connector (Multi-ICE Interface, Trace 32 etc.)
1.2 SYSTEM REQUIREMENTS
This section describes the hardware and software system requirements.
ARM Compiler SW
Software Requirements
ARM Debugger SW
S3F401F EVB Board Set
Power Supply DC 7~12V ( Recommend Default 12V)
Debugger (Multi-ICE or Trace 32 etc.)
PC(Pentium, 32MB RAM for Windows 95, or 64MB RAM for Windows NT)
COM Port for serial communication
Hardware Requirements
Parallel Port (If using Multi-ICE)
