134
–
Tap
New Outgoing Port
to choose a device and set up a new
outgoing port.
• Dial Up Network Terminal
: No configurable settings.
• Basic Printing
: No configurable settings.
• File Transfer
: Tap
Options
for these settings:
–
Tap
Enable to write
to enable/disable writing to your device.
–
Tap
Shared Folder
to choose a location on your device for sharing.
• Object Push
: Tap
Options
for these settings:
–
Tap
Enable to receive all Incoming
to enable/disable automatic
receiving for incoming beams.
–
Tap
Shared Folder
to choose a location on your device for sharing.
• Human Interface Device
: No configurable settings.
• Phonebook Access
: No configurable settings.
9. Tap
Menu
➔
Device Info
for settings about your device:
•
Tap
Device Name
to modify your device’s name, to be using during
pairing.
•
View the
MAC
address, which is needed for some pairings.
•
Enable visibility
to other devices to put your device in discoverable
mode, visible to other searching Bluetooth devices.
•
If in discoverable mode, tap
Turn off Visible Mode
to set a length of
time to remain discoverable. Choose from
Never
,
After 1 Minute
,
After 5 Minutes
, or
After 10 Minutes
.
Note:
The Device Name that appears on the above screen can also be
changed via the Owner Information Settings. For more information, see
“Owner Information” on page 95.
Bluetooth Bonds
A bond is a relationship that you create between your Omnia II
and another Bluetooth-enabled device to exchange information in
a secure manner. Creating a bond involves entering the same
Passkey on the two devices sharing a bond.
Bonds are created only once between devices. Once a bond is
created between devices, the devices do not have to be
discoverable to exchange information; however, each device
must have its Bluetooth radio on.
Creating Bluetooth Bonds
Note:
Make sure that the two devices are within range of one another and
that Bluetooth discoverable mode is enabled on both devices.
1. Press the
Main Menu
key ,
Main Menu 2
➔
Bluetooth
.
– or –
Press the
Main Menu
key , then
Settings
➔
Basic Settings
tab ➔
Bluetooth Settings
.
2. Turn on
Bluetooth
by tapping the blue device icon.
