4-3
Controlling
Input selection.
Two possible ways of selecting an input :
a) Display General access menu with RCU by pressing ADJ but-
ton. This brings up a secondary general access menu. Choose
source selection and highlight desired source.
b) With the local keypad :
Press first the ADJUST key to display the General access menu.
Use the control disk to highlight the desired source number.
Choose from table above. Push the control disk up or down to
move the cursor up and down, push the control disk to the left or
to the right to move the cursor to the left and to the right.
Press ENTER to confirm your selection.
When a valid and available source is selected, there will be infor-
mation displayed on the screen about that source. This informa-
tion includes :
- Source number
- Horizontal frequency
- Vertical frequency
When the entry is a non valid source number, a warning appears
on the screen : ‘input not available’.
When a valid source number is selected, the projector will display
this source or it will wait on the selected source number until the
source becomes available. A message ‘source not available’ will
be displayed for a short time.
then <ENTER>.
