15
Make settings for the divided pickup
Specify the pickup type
(1 GK TYPE)
* With the factory settings, this is set to “1 GK-2A.”
1. Press [PARAMETER ▼/▲] until “1” is shown (blink) at
the left side of the display.
This selects “1 GK TYPE.”
fig.04-2
2. Press [SELECT/VALUE ▼/▲] to select the desired
pickup type.
The corresponding number will appear in the right of
the display.
* The example display shows that “1 GK-2A” has been selected.
* A piezo-type pickup uses a piezo-electric sensor attached to the
bridge of the guitar to detect the vibrations of the strings.
Specify the direction in which the
pickup is attached (2 DIRECTION)
* With the factory settings, this is set to “1 NORMAL.”
1. Press [PARAMETER ▼/▲] until “2” is shown (blink) at
the left of the display.
This selects “2 DIRECTION.”
fig.05
2. Press [SELECT/VALUE ▼/▲] to select the direction in
which the divided pickup is installed.
The corresponding number will appear in the right of
the display.
* The example display shows that “1 NORMAL” has been
selected.
fig.86
Display
Setting
1 GK-2A: Make this setting if you are
using a GK-2A.
2 GK-2: Make this setting if you are
using a GK-2.
3 PIEZO: Make this setting if you are
using a piezo divided pickup.
1
2
Display
Setting
1 NORMAL: In this direction, the cable
exits on the side of string 6.
2 REVERSE: In this direction, the cable
exits on the side of string 1.
1
2
NORMAL
REVERSE
string 6 string 1
