A SERVICE OF

logo

Open as PDF
next previous
September 25, 2012
7075-166
Page 23
VOYAGEUR GRAND Wood Insert
R
Figure 23.1
F. Bafe & Ceramic Blanket Removal
1.Removeallashfromtherebox,andextinguishallhot
embers before disposal into a metal container.
2. Itiseasiertoremovebothbafeboardsandceramic
blanketafterthetubechannelassemblyhasbeenpartially
disassembledandtherightsidelowered.Followsteps
1 through 4 on page 25 for removal of the tube channel
assembly. It is not necessary to completely remove the
tube channel assembly.
3. Oncethebafeprotectioncoverhasbeenremoved,pull
thebafeboardsandceramicblanketforwardabout1inch
(25mm)andthenoverlapthebafesabout1-2inches(25-
51mm). Figure 23.2.
4. Slidethetubechannelassemblytotheleftasfarasitwill
goandlowertherightside.Removethebafeboardsand
ceramicblankettogether.Figure 23.3.
4. Re-installinreverseorder.Besurethebafeboardsand
ceramicblanketareintheirproperpositions.See Figure
11 .1 on page 11.
E. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slidedoorhandlethroughdoor.
3. Install additional washer(s) as shown in Figure 23.1.
4. Installkeyingroove.
5. Aligngrooveinlatchcamwithkey;slidelatchcamover
shaft
6. Installlocknutbutdonotovertighten,thehandleneeds
to move smoothly.
7. Installhandleturninginacounter-clockwisemotionto
desired location on door handle rod. Figure 23.1.
CAUTION!Donotovertightenlocknut.Thedoorhandle
needstomovesmoothly.
Locknut
Latch Cam
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
Figure 23.2
Figure 23.3
Slide Tube Channel to the
Left and Lower Right Side
Baffle Boards Overlapping
Ceramic Blanket