3. With the help of a second person, carefully tip the
Uprights (64) back to the vertical position.
Attach the Latch Assembly (32) to the left Upright (64)
with two Extension Screws (35).
4. Turn the Handrail Extension (34) so that the two larger
4
82
holes are on the bottom as shown. Insert the Handrail
Extension into the post on the left Upright (64) as far as
\,....
.,z
possible. If necessary, tap the Handrail Extension with a
31
Post
----::/10:
rubber mallet to fully insert it. Next, attach the Handrail
ti.
.
--
ittf
/
Extension by tightening
three
Extension Screws (35) into
the indicated holes.
-4,
-,.
.!"
-
■
"-
,
Identify the Left Foam Grip (31) (see the inset drawing).
'',.-
---
34
Remove the paper from the two indicated pieces of Foam
V
9
64
/ /
Tape (82). Apply a small amount of water to the pieces of
Foam Tape. Slide the Left Foam Grip as far as possible
Holes
onto the post on the left Upright (64).
Note: It may be
r
311
helpful to lubricate the Handrail Extension (34) with
wr 43
soapy water.
Press two Plastic Fasteners (9) into the
1
1
Foam Grip and the Handrail Extension. If necessary, use
[
a blunt object to press in the Fasteners.
9
T
Attach the other Handrail Extension (not shown) and the
Right Foam Grip (43) as described above. Note: Make
sure that the Extension Screws (35) are attached on the
outside of the post as shown.
5.
Make sure that all parts are tightened before you use the treadmill.
Keep the included allen wrench in a
secure place; the allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
7
