45
FEATURES
Instrumentation
MFD Digital Display Programs
History Program
Service Interval Reminder
To reset the reminder at a new interval:
1. Enter the History Program.
2. Press and release the SET button until the service interval screen is
active.
3. Press and hold the SET button for five seconds, until the hours begin
to flash. Immediately release the button.
4. Press the button again, up to five times, to advance the reminder in
50-hour increments.
Tip: The maximum interval is 250 hours.
5. Press and release the MODE button to save the new settings.
To disable the service interval reminder:
1. Press the SET button once after reaching 250 hours on the display.
The gauge will display "OFF".
Gauge Cleaning
1. Wipe the gauge face as needed using a clean cloth and a mild soap
and water solution. Wipe dry with clean, soft cloth.
2. Clean the back side of the gauge using a clean cloth and a mild soap
and water solution. Do not remove the electrical connectors or pro-
tective rubber boot. Do not spray the back side of the gauge or the
wire harness with a pressure washer or other water source.
NOTICE: To prevent damage to the lens, do not use alcohol for cleaning. Do not
allow chemicals or sprays to contact the lens. Immediately clean off
any gasoline that splashes on the gauge during refueling.
