82
Techno Tidbits & Problem-solving
Specifications
FM Tuner Section
Frequency Range ......................... 87.5 MHz to 108 MHz
Usable Sensitivity...... Mono: 13.2 dBf, IHF (1.3 µV/75 Ω)
50 dB Quieting Sensitivity.......................Mono: 20.2 dBf
Stereo: 38.6 dBf
Signal-to-Noise Ratio ................. Mono: 73 dB (at 85 dBf)
Stereo: 70 dB (at 85 dBf)
Distortion ...................................... Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity ................. 60 dB (400 kHz)
Stereo Separation ...................................... 40 dB (1 kHz)
Frequency Response ............... 30 Hz to 15 kHz (± 1) dB
Antenna Input .......................................75 Ω unbalanced
AM Tuner Section
Frequency Range .......................... 530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna)......................... 350 µV/m
Selectivity............................................................... 25 dB
Signal-to-Noise Ratio .............................................. 50 dB
Antenna...................................................... Loop antenna
Miscellaneous
Power Requirements ............................. AC 120 V, 60 Hz
Power Consumption ................................400 W, 550 VA
Power Consumption in Standby mode .................. 1.0 W
AC Outlet
SWITCHED (×2) ................ Total 100 W (0.8 A) MAX
UNSWITCHED...........................100 W (0.8 A) MAX
Dimensions .................. 420 (W) × 173 (H) × 470 (D) mm
................ 16-9/16 (W) × 6-13/16 (H) × 18-1/2 (D) in.
Weight (without package) ................. 14.1 kg (31 lb 1 oz)
Furnished Parts
FM Antenna ...................................................................1
AM Loop Antenna ..........................................................1
Dry Cell Batteries (SIZE “AA” (IEC LR6)) .......................2
Remote Control Unit ......................................................1
Operating Instructions ...................................................1
NOTE:
Specifications and the design are subject to possible
modifications without notice, due to improvements.
Amplifier Section
Continuous average power output of 100
watts* per channel, min., at 8 ohms, from
20 Hz to 20,000 Hz with no more than 0.09
%** total harmonic distortion (front).
Continuous Power Output
Front ..... 100 W + 100 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Center ................. 100 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Rear ...... 100 W + 100 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Input (Sensitivity/Impedance)
PHONO MM ..............................................4.7 mV/47 kΩ
VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE
1, TAPE 2...............................................335 mV/47 kΩ
Frequency Response
PHONO MM ...................... 20 Hz to 20,000 Hz ± 0.3 dB
VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE
1, TAPE 2..............................5 Hz to 100,000 Hz dB
Output (Level/Impedance)
VCR 1 REC, VCR 2 REC, MD/TAPE 1 REC, TAPE 2 REC
.........................................................335 mV/2.2 kΩ
Tone Control
BASS ...................................................± 6 dB (100 Hz)
TREBLE ............................................... ± 6 dB (10 kHz)
LOUDNESS ..............................+3 dB (100 Hz/10 kHz)
Signal-to-Noise Ratio (IHF, short circuited, A network)
PHONO MM ...................................................... 80 dB
VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE,
TAPE 2................................................................ 97 dB
Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]
PHONO MM ...................................................... 80 dB
VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE,
TAPE 2................................................................ 83 dB
* Measured pursuant to the Federal Trade
Commission’s Trade Regulation rule on Power
Output Claims for Amplifiers.
** Measured by Audio Spectrum Analyzer.
VIDEO Section
Input (Sensitivity/Impedance)
VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO .......1 Vp-p/75 Ω
Output (Level/Impedance)
VCR 1, VCR 2, MONITOR .........................1 Vp-p/75 Ω
Frequency Response
VCR 1, VCR 2, MONITOR ......... 5 Hz to 10 MHz dB
Signal-to-Noise Ratio .............................................. 55 dB
+0
–3
+0
–3
