3 Press the lter capacity selection button again until the display
shows the capacity of your lter cartridge (1500-2500-900-1500
etc.).
4 Stop pressing the lter capacity selection button when the display
shows 2500 litres.
The selected lter capacity and the remaining lter capacity are
shown for 5 seconds.
Using the appliance
1
Turn the water selection lever to the desired setting (‘click’).
The water selection level has 3 settings: ltered spray, unltered spray and
unltered stream. See the sections below.
2 Open the tap.
Filtered spray
Select this setting for drinking, washing vegetables or fruits and
for cooking.
1 Turn the water selection lever until the ltered spray symbol is
aligned with the indicator (Fig. 26).
Do not let water hotter than 50°C run through the water purier at
this setting, as this may damage the water purier.
If you lter water between 35°C and 50°C, the water may have an
unpleasant smell. The lter cartridge has absorbed this smell during
ltering, but releases it again if you lter water hotter than 35°C.
2 Open the tap.
Filtered spray comes out of the water purier.
The display is on and counts down the remaining lter capacity.
Note: The LCD display only shows the remaining lter capacity when you use
the water purier at the ltered spray setting and when the water pressure is
more than the minimum required 0.7kgf/cm² (7 meters of water column).
Note: The display is off when you do not use the water purier and when you
use it at the unltered spray and unltered stream settings.
,
,
,
ENGLISH 13
