10 Turning on Your VCR
Before turning on your VCR, make sure there are batteries in the
remote control and the VCR, TV, and Cable Box/DBS (if applica-
ble) are connected.
1
Press the VCR button, then press the POWER button.
2
Turn on the TV. Set it to channel 3 or 4, whichever the
CH3/CH4 switch on the back of the VCR is set to. The
menu shown below will appear.
3
Press the PLAY 8 or STOP 9 button to select the on-
screen display language.
2
Turn on the TV.
5
Press the :/OK button to begin automatic channel setup.
AUTO CH. SET PROCEEDING PLEASE WAIT will appear on-
screen. The VCR will memorize all of the channels you receive, so
when you scan through channels using the CH(annel) 8/9 but-
tons, you’ll only scan through channels that you receive.
4
Press the :/OK button. The menu shown below will appear.
6
When channels are set up, AUTO CH. SET COMPLETED will
appear on-screen briefly.
6
Wait for the VCR to set up
channels.
SELECT , 9
A ENGLISH
ESPAÑOL
FRANÇAIS
MAKE SELECTION OR
PUSH :/OK TO CONTINUE
CONNECT ANTENNA OR CABLE
TO VCR
THEN PUSH :/OK KEY
OR . . .
FOR PLAY ONLY – PUSH STOP
• Auto or – – : – – may appear on
the display panel until the clock is
set. After you connect the anten-
na/cable signal to the VCR and con-
nect the VCR to a power source, the
clock may set itself automatically.
The current time may appear on
the VCR display panel.
• If you do not want to set up chan-
nels now, press the STOP 9 button
at step 5. TUNER NOT SET will
appear on-screen briefly.
• You may not set up channels at
step 5 if you are using a Cable
Box/DBS.
Helpful Hints
3
4
1
5
