8 EN
Adjust
volume.
Slide up/
down VOL
+/-
1 short beep
Skip forward. Press 1 short beep
Skip backward. Press
twice
1 short beep
Mute/
unmute the
microphone in
a call.
Press 1 short beep
/ 2 short
beeps
Activate voice
dialing
Press
twice
2 short beeps
before dial
tone
Note
• Available if supported by your mobile phone.
Other status and indicators
Headset Status Indicator
The headset is connected
to a Bluetooth device,
while the headset is in
standby mode or while
you are listening to music.
Blue LED ashes
every 8 seconds.
The headset is ready for
pairing.
LED ashes
white and blue
alternately.
The headset is on but not
connected to a Bluetooth
device.
Blue LED ashes
fast.
There is an incoming call. Blue LED ashes
twice per second.
Low battery. White LED
ashes.
Battery is fully charged. White LED is off.
The LED is off. The headset is
off./Charging is
nished.
The headset beeps every
5 seconds.
The microphone
is muted.
Wear your headset
Adjust the headband for the best t.
Tip
• After use, twist both earshells, fold the headset at for
storage.
Use with the audio cable
With the supplied audio cable, you can use the
headset with non-Bluetooth enabled devices or
use the headset on airplane. No battery power
is required when you use the headset with the
audio cable.
Caution
• Finish your call before connecting the audio cable, as
this will switch off battery power and end an incoming
call.
Connect the supplied audio cable to
• the headset and;
• an external audio device.
