![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/e/64/e6409ef8-838a-43a3-ac10-19c9fc3fffc6/e6409ef8-838a-43a3-ac10-19c9fc3fffc6-bg16.png)
22
English
3139 116 19782
TIMER
STEREO
FM
BACK
HSD
REPEAT
LW
MW
AM
T.A.
NEWS
SOUND NAVIGATION
DIGITAL SOUND
CONTROL
DYNAMIC BASS
BOOST
TAPECD
PROG
CLOCK/
TIMER
DUB
(HSD)
REC
STANDBY
ON
SIDE A•B
A.REV
TUNER AUX
PRESET
▲
▲
STOP•CLEARSEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
CD1 • 2 • 3 CDR / VIDEOBAND TAPE 1 • 2
FRONT
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
REC
PROGRAM
SS
LR
C
PRO LOGIC
SIDE
MIC
MIC
LEVEL
RECORDING
SWITCH OFF DOLBY PRO LOGIC
WHEN RECORDING
Notes:
– It is not possible to change tape side
during recording.
– If you do not intend to record via the
microphone, unplug the microphone to
avoid accidental mixing with other
recording source.
– For recording, use only tape of IEC type I
(normal tape) or IEC type II (Cr0
2
).
– The tape is secured at both ends with
leader tape. At the beginning and end of
tape, nothing will be recorded for six to
seven seconds.
– The recording level is set automatically,
regardless of the position of Volume,
DBB or DSC.
– To prevent accidental recording, break
out the tab on the left shoulder of the
tape side you want to protect.
– If “
CHECK TAPE
” is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Cr0
2
tape
detection hole when covering the tab
opening.
Recording from other sources
(only on tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load a blank tape into tape deck 2 with
the open side downward.
3 Press í or ë to select the recording
tape side
(see Tape Side under TAPE
section)
.
4 Press CD, TUNER or AUX.
• Start playback of the selected source.
5 Press REC to start recording.
™ The REC starts flashing.
6 Press Ç to stop recording.
Notes:
– Only
åå
åå
å
or
∂∂
∂∂
∂
mode is available
during recording .
– During recording, it is not possible to
listen to another source.
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 with full spool to the left and a
blank tape into tape deck 2 with full
spool aside.
3 Press í or ë to select the recording
tape side
(see Tape Side under TAPE
section)
.
Untitled-2 6/8/01, 10:13 AM22