19
English
Preparations
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
3
2
1 Open the battery compartment.
2 Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3 Close the cover.
Using the remote control to operate the
system
1 Point the remote control directly
at the remote sensor (iR) on the
front panel.
2 Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE1/2, TUNER).
3 Then select the desired function (for example
2;, O or P).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
The clock can be set in either 12-hour or 24-
hour mode (“PM 00:00” or “00:00” for
example).
1 The clock can be set in any source mode.
➜ If you have not set the clock, “--:--” will be
shown on the display.
2 Press and hold CLOCK and “00:00” blinks on
the display.
➜ The current time is flashing on the display.
➜ If you have not set the clock, “--:--” will appear
on the display.
3 Press O or P on the system to set the
hours.
4 Press 1 or ¡ on the system to set the
minutes.
5 Press CLOCK to confirm your setting. Clock
will be shown on the display for 5 seconds and
then go back to it’s previous status. The system
will store the setting automatically.
➜ The time setting becomes effective.
To exit the setting without storing (in
standby mode)
● Press 9 on the system to exit.
➜ “CANCEL” will appear on the display.
● Press ECO POWER/ STANDBY ON to exit
setting mode and go into ECO POWER
mode.
● You can also press DISC, DISC1~3, DISC
CHANGE, OPEN/CLOSE to exit setting
mode and go into disc mode.
● The system will also exit setting mode and go to
TUNER, TAPE or AUX/GAME mode when you
press the corresponding source button.
Viewing the clock in any source mode
● When you have set the clock, press CLOCK on
the system to view clock (or press CLOCK/
TIMER on the remote control). Press
DISPLAY on the system to toggle between 12-
hour and 24-hour modes.
➜ The time will be displayed for 5 seconds and
then go back to it’s previous status.
