DIGITAL TUNER
7
English
Tuning to radio stations
1.
Select TUNER source.
™ is displayed briefly and then the radio station
frequency is shown.
2.
Press BAND once or more to select your waveband.
3.
Press SEARCH ∞ or § (on the remote control, TUNING ∞
or §) and release when the frequency in the display starts
running.
™ The tuner automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
™ If an FM station is received in stereo,
STEREO is shown.
4.
Repeat step
3
if necessary until you find the desired station.
• To tune to a weak station, press SEARCH ∞ or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception:
• For
FM
, pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal is
too strong (very close to a transmitter).
• For
MW (LW)
, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1.
Tune to your desired station (see Tuning to radio stations).
2.
Press PROG to activate programming.
™ Display:
PROG flashes.
3.
Press PRESET 3 or 4 once or more to allocate a number from
1 to 30 to this station.
4.
Press PROG again to confirm the setting.
™ Display:
PROG disappears, the preset number and the frequency
of the preset station are shown.
5.
Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press TUNER PRESET 4 or 3 until the desired preset station is
displayed.
AZ 1565/00 page 7
