![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/3/cb/3cb2e60b-b4f0-4f51-9800-a9e4fc8c5587/3cb2e60b-b4f0-4f51-9800-a9e4fc8c5587-bg9.png)
CD player and CD handling
• If the CD player cannot read CDs correctly,
use a cleaning CD to clean the lens before
taking the set to repair.
• The lens of the CD player should never be
touched!
• Sudden changes in the surrounding
temperature can cause condensation on the
lens of your CD player. Playing a CD is then
not possible. Do not attempt to clean the lens
but leave the set in a warm environment until
the moisture evaporates.
• Always close the CD door to avoid dust on
the lens.
• To clean the CD, wipe in a straight line from
the center towards the edge using a soft, lint-
free cloth. Do not use cleaning agents as they
may damage the disc.
• Never write on a CD or attach any stickers
to it.
Safety information
• Place the set on a flat, hard and stable surface
so that the system does not tilt.
• Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
• Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
• The apparatus shall not be exposed to
dripping or splashing.
• Adequate ventilation with a minimum gap
of 15cm (6 inches) between the ventilation
holes and surrounding surfaces is necessary to
prevent heat build-up.
• Do not cover the ventilation openings with
items such as newspapers, table-cloths,
curtains, etc.
• No objects filled with liquids, such as vases,
shall be placed on the apparatus.
• No naked flame sources, such as lighted
candles, should be placed on the apparatus.
• The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
• To clean the set, use a dry cloth. Do not
use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.
Maintenance & Safety
(See
8
)
AZ302_CCR_Eng.indd 9AZ302_CCR_Eng.indd 9 2008-02-01 10:54:54 AM2008-02-01 10:54:54 AM