A SERVICE OF

logo

Open as PDF
next previous
12 C2634M (5/07)
Reassemble the Unit
1. Replace the chassis cover using the same screws you removed from the side and rear of the unit. Refer to Figure 10.
Figure 10. Replacing Chassis Cover
2. Attach the silver part label that came in your upgrade kit to the inside of your DVR’s front door.
a. Remove the paper backing from the part label.
b. Carefully place the label, adhesive-side down, on a free section of the inside of the door.
c. Press down firmly to ensure that the label properly adheres to the inside of the door.
NOTE: In the event that your unit or its components require service, part labels must be present and appropriately affixed
to the unit’s door. Pelco product support personnel use these labels to identify the exact components installed in your
system. A separate part label is required for each upgrade component installed on the DX8100.
Figure 11. Product Label
DX8100-512RAM
04070-FDF-C6B6