16
Attaching the foot (if using the loudspeaker in a free standing mode)
1. Loosen the bracket knobs and remove the bracket from the loudspeaker.
2. Tighten the top knob so it does not vibrate.
3. Remove the bottom knob by unscrewing it from the cabinet.
4. Place the supplied shelf stand on the loudspeaker with the two shorter feet
towards the front of the loudspeaker (See Figure 10). Make sure the ridges on the
shelf stand engage the ridges on the cabinet.
5. Tighten the bottom knob so that the shelf
stand does not move.
Connecting the Loudspeaker
1. Separate the two conductors of the loudspeaker wire so that at least two inches
of each conductor are free.
2. Strip one half inch of insulation from the end of each conductor of the
loudspeaker wire.
3. If you have any connectors (gold pins or bananas) which you prefer to use, affix
them to the stripped wire ends now. Only gold plated connectors should be used
outside as they will not tarnish or corrode.
4. If using the bracket to attach to a solid surface, slide the loudspeaker onto the
bracket. Do not tighten the knobs completely. Angle the loudspeaker so that the
rear terminals are accessible. If using the shelf stand, position the loudspeaker
on the stand and place it on the shelf or table where you want it.
INSTALLATION
Figure 10 Mounting the shelf stand on
the OS loudspeaker
Bottom of the OS
DS00426ACN_OS_5.qxp 12/20/04 5:46 PM Page 15
