YML881Rev1 V110,V210P,V211,V220V110, V210P, V211, V220 User Guide
www.netcomm.com.au 61
How to make a phone call
Dial a VoIP Phone call
When your VoIP Gateway is configured properly, you can make a phone call via VoIP.
If you want to make a phone call, you can dial the phone number and press “#” button to start to dial the
phone number.
Dial a PSTN Phone call (V210P/V211)
By default outgoing calls should be placed with the VoIP service. If you want to make a phone call via the
PSTN pass-through port, you can press “0*” and dial the phone number.
Note: On loss of power, the V210P/V211 will switch all calls from the FXS port through to the PSTN pass-through.
The VoIP Gateway also provides some functions that list as below:
Call Features
The NetComm ATA also provides some functions that list as below:
Blind Transfer
This feature allows a user (transferor) to transfer an existing call to another telephone number (transfer target)
without connecting to the transfer target number.
How to Use:
1. During an existing call, perform a hook flash to put the other party on hold and get a dial tone.
2. When you hear the dial tone, press #510# on your telephone dial-pad.
3. When you hear the dial tone indicating that the VoIP Gateway is expecting a number, dial the phone
number to which you want to transfer the other party, then press # (optional) and then hang up the
phone.
Attendant Transfer
This feature allows a user to transfer an existing call to another telephone number after first consulting with
the dialed party (transfer target) before hanging up.
How to Use:
1. During an existing call, perform a hook flash to put the other party on hold and get a dial tone.
2. When you hear the dial tone, press #511# on your telephone dial-pad.
3. When you hear the dial tone, dial the telephone number to which the existing party is to be transferred,
then press # (optional).
4. When the target transfer answers the phone, you may consult with the target transfer, and then hang up
your phone to transfer the call to the target transfer.
