NetComm Gateway Series Manual

A SERVICE OF

next previous

54 SmartVoice Gateway(s) User Guide

YML832 Rev2

Connected to a PBX Extension Line

If the gateway is connected to a PBX extension line, then the busy tone of both the PBX and the PSTN

must be detected.

Connecting to a PBX extension line and detecting the busy tone of the PBX

36008913

307

301

Note: The above diagrams show a 4-port SmartVoice gateway for illustration purposes.

An 8 port SmartVoice gateway could also be used depending upon your network

requirements.

•Connect one of the PBX extension lines to the Gateway FXO Port.

•Detect Channel: Enter 4 (if the trunk line is connected to P4, and uses P4 for outgoing detection).

•Phone Number: Set the number of the FXO line –to detect Reorder Tone.

• Dial Number: Enter the number of the end to be tested—307.

•CPT group: Enter the group to save your settings to once the test has been completed.

•Finally, click the “Accept” button.