FIGURE 13
15
STEP 13:
• Wrap the CABLE (21) around one 4-1/2” PULLEY (19) and SECURELY assemble the pulley to the REAR slot of the PRESS ARM
ADJUST (5) using one 3/8 X 2-3/4” BOLT (37), two 3/8” FLANGE SPACERS (52), and one 3/8” LOCK NUT (45) as shown in FIGURE
13. (NOTE: Loop the cable over the pulley prior to inserting it into the slot.)
• SECURELY assemble one of the threaded ends of the CABLE (21) 3/4 of the way into the threaded post on the PRESS BASE
(2) as shown in FIGURE 13.
• Route CABLE (21) through the slot in the PRESS BASE (2) then SECURELY assemble one 4-1/2” PULLEY (19) to the PRESS BASE (2)
using two 3/8 X 3-3/4” BOLTS (34), two 3/8” FLANGE SPACERS (52), two 2-7/8 X 2-1/4” CABLE CLIPS (2), two 1/2” SPACERS (53), two
3/8” WASHERS (42), and two 3/8” LOCK NUT (45) as shown in FIGURE 13. (NOTE:Make sure the cable is in the groove of the pulley
and over the top of the retaining bolt before tightening it.) (NOTE: Position CABLE CLIPS as shown.)
• Wrap the CABLE (21) around one 4-1/2” PULLEY (19) and SECURELY assemble the pulley to the FRONT slot of the PRESS ARM
ADJUST (5) usinng one 3/8 X 2-3/4” BOLT (37), two 3/8” FLANGE SPACERS (52), and one 3/8” LOCK NUT (45) as shown in FIGURE
13. (NOTE: Loop the cable over the pulley prior to inserting it into the slot.)
34 3/8 X 3-3/4”
5
52
2
19
19
45
21
19
4
37 3/8 X 2-3/4”
53
52
45
34 3/8 X 3-3/4”
45
42
57
