3
SETTING UP
Please follow those steps for connecting your radio to your network
Step 1- Switching on the radio;
Plug the cable from the AC Cord into the socket on the back of the radio, then switch on at the
mains.
Caution: Only use the AC Cord that supplied with the radio. Connecting a power supply with a
different rating will cause permanent damage to the radio and may be hazardous.
The display on the front of the radio will light up and say:
Followed by:
If you listen to the Internet radio and Media player before you turned off the radio, it will be
automatically switched to Internet radio mode; Or if you was listening to FM radio, it will be
automatically switched to FM radio mode.
After a few seconds, this will change to show:
Step 2- Connect to network connection:
Note: If you make a mistake at any point, press the BACK button to go back to the previous
screen.
Note: At first, you need to select network;
(1)Press the SELECT button;
(2)Press Tune up or down until the display says “Configure”;
(3) Press the SELECT button;
(4) Press Tune up or down until the display says “Network Config”;
Reciva Enabled
Initializing
Connecting to
Configure
Network Config
