• Pull the AC QUICK CONNECTOR through the center hole in the ring and
mount the ring, making sure that the mounting screws are positioned in the
small ends of the keyholes before tightening the screws (see fig. 3).
• Plug the AC QUICK CONNECTOR into the back of the strobe light, (see fig. 4)
making sure that the locks on the connector snap into place.
• If you have finished all the WIRING AND TRIM RING MOUNTING STEPS, you
can install the strobe light on the trim ring. Alignment marks are provided on
the side of the strobe light and on the Install the strobe light on the trim ring
with the indicating marks aligned and rotate the detector in the direction of
the ON arrow on the cover until the strobe light snaps in place. (See fig. 5)
• Turn on the AC power, The model SL177i strobe light has a green AC power
on indicator which should be lit when the strobe is operating from AC power.
TAMPER RESIST LOCKING PIN: To make your strobe light tamper resistant a lock-
ing pin has been provided with your strobe light. Using this pin will help deter
individuals from removing the strobe light from the trim ring. To use the pin
insert it into the hole in the side of the strobe light after the strobe light has
been installed on the trim ring (see fig. 6). NOTE: The tamper resist pin will have
to be removed in order to remove the strobe light. This can be done easily with
a long nose pliers. Using the long nose pliers, pull the pin out of the hole, it is
now possible to remove the strobe light from the trim ring.
After installation TEST your strobe light by following the test procedure outlined
in section 6.
CAUTION! Early warning fire detection and visual notification is best achieved by
the installation of fire detection and visual notification equipment in all rooms
and areas of the household as follows: A smoke alarm and visual notification
To remove AC
connector,
squeeze
locking
arm and
pull.
Tamper resistant
locking pin
Alignment Marks
Remove
Install
FIGURE 4 FIGURE 5 FIGURE 6
