10
You can preset up to 30 FM stations and 15 AM (MW/LW)
stations.
Note: Preset numbers may have been set to factory test
frequencies prior to shipment. This is not a malfunction.
You can preset the stations you want into memory by
following one of the presetting methods below:
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start again from step .
■
1. Select a band (either AM or FM) by
pressing TUNER BAND.
■
2. Press 4 or ¢ to tune in to a station.
■
3. Press SET.
The preset station number starts flashing.
■
4. Press the number buttons to select the
preset number you want.
■
5. Press SET.
“STORED” appears on the display and the station is stored.
■
6. Repeat above steps to for each
station you want to store into memory with
a preset number.
To change the preset stations, repeat the same steps as
above to overwrite a new station.
CAUTION: To prevent the preset stations from
being erased because of a power failure, etc.,
install memory backup batteries in the system.
(See pages 5 and 6.)
■■
Playing back discs
This system has been designed to play back the following
discs—CD, finalized CD-R/CD-RW (recorded in audio CD
format) and CD-R/CD-W (in MP3 format).
• This system is not compatible with the other discs such as DVD,
DVD-R, and DVD-RW.
Notes on MP3:
• The system can only recognize files (tracks) with “MP3” or
“mp3” as the extensions, which can be in any combination of
upper and lower case.
• It is recommended that you record your material at a 44.1 kHz
sampling rate, using the 128 kbps data transfer rate.
• You can play back the discs containing the tracks in music CD
format or MP3 files in ISO 9660 format.
• Some MP3 tracks or discs may not be played back because of
their characteristics or recording conditions.
• MP3 discs require a longer readout time than normal discs.
• This system recognizes up to 999 tracks on a disc (or less
depending on the recording condition of a disc).
■
1. Turn the LOCK/RELEASE knob
counterclockwise to open the disc
compartment door.
■
2. Place a disc, with its label side up as
shown above.
■
3. Close the disc compartment door and turn
the knob to “LOCK” position.
To remove the disc, open the disc compartment door in stop
mode.
■ You can place an 8 cm disc without an adapter.
■ If the disc cannot be read correctly (because it is scratched, for
example), “NO PLAY” or “NO DISC” appears on the display.
■ You can place a disc while listening to the other source.
Presetting stations
Using the remote control only
3.
1. 5.
LOCK/RELEASE knob
7
CD 6
4
¢
7
4¢
Number buttons
REPEAT
CD 6
PLAY MODE
GROUP UP
GROUP DOWN
CANCEL
1
1
2
3
G 2
G 1
G 3
G 4 G 5
G 6
10
11
12
4
5
6
7
8
9
G 1
(ROOT)
Hierarchy
Level 1 Level 2 Level 3 Level 4 Level 5
Group with its play order
MP3 track with its play order
Setting a disc
RV-NB1[B]f.book Page 10 Friday, July 16, 2004 5:42 PM
