34 – English
Engine
Cylinder volume, cu.in/cm
3
Cylinder bore, inch/mm
Stroke, inch/mm
Idle speed, rpm
Power, kW/ rpm
Ignition system
Manufacture
Type of ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication system
Manufacturer
Carburetor type
Fuel capacity, US pint/litre
Oil pump capacity at 8500 rpm, ml/
min
Oil capacity, US pint/litre
Type of oil pump
Weight
Without bar and chain, Lbs/kg
Chain/bar
Recommended bar lengths,
inches/cm
Usable cutting length, inches/cm
Chain speed at max. power, m/sec
Pitch, inch/mm
Thickness of drive link, inch/mm
Number of teeth on drive sprocket
TECHNICAL DATA
Guide bar Saw chain
Length Pitch Max teeth
inch inch radius
16-32 3/8" 11T Jonsered S42 or
Oregon 73LP / 73LG or
Sabre 988 PC
0,050"/1,3 mm – 72LP 72LG 980PC
0,058"/1,5 mm S42 73LP 73LG 988PC
0,063"/1,6 mm – 75LP 75LG 983PC
Recommended original and replacement
bar and chain combinations
These Jonsered saw models are in the ANSI category of saws
above 3,8 cu. in. and are not
required
to comply with kickback
performance requirements. However, for these models we
recommend the following cutting equipment.
WARNING! These models of chain saws are capable
of severe kickback that could result in serious
injuries to the user. Do not operate these saws unless
you have extraordinary cutting needs and experience
and specialized training for dealing with kickback.
Saws with significantly reduced kickback potential
are available. Always use the safest saw and cutting
equipment applicable to your cutting need.
Note: For the chains above you are free to choose between 0,050",
0,058" and 0.063"gauge drive link for the corresponding bar, see the
table below.
The combinations of powerhead, bar and chain have been
investigated in accordance with the vibration requirements of
ANSI B 175.1-2000.
CS 2186
5,2/84,7
2,1/54
1,5/37
2 700
4,6/ 9 600
FHP
CD
Champion RCJ 7Y
0,02/0,5
Tilotson
HS296A
1,6/0,9
4-20
0,9/0,5
Automatic
15,6/7,1
W: 16,1/7,3
16-32"/40-80
15-31"/38-78
21,4
3/8"/9,52
0,050"/1,3
0,058"/1,5
0,063"/1,6
7
´*xt[¶5b¨
