5
english
JABRA BT530
Turning your headseT on and off
- Slide the on/o button forward on the side of the headset to
turn on the headset. The LED will ash green for a second when
the headset is on.
- Slide the on/o button backward to turn o the headset.
Pairing iT WiTh your Phone
Headsets are connected to phones using a procedure called
‘pairing’. By following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
1. Put the headset in pairing mode
- When you turn on your Jabra BT530 for the rst time, the
headset will automatically start up in pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the LED is constantly lit.
2. Set your Bluetooth phone to ‘discover’ the Jabra BT530
- Follow your phone’s instruction guide. First make sure that
Bluetooth is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going
to a ‘setup,’ ‘ connect’ or ‘Bluetooth’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a Bluetooth device.*
3. Your phone will nd the Jabra BT530
- Your phone will nd the headset under name “Jabra BT530”.
Your phone then asks if you want to pair with the headset.
Accept by pressing ‘Yes’ or ‘OK’ on the phone and conrm with
the passkey or PIN = 0000 (4 zeros). Your phone will conrm
when pairing is complete.
In case of unsuccessful pairing, put the Jabra BT530 into pairing
mode manually. Make sure the headset is on. Press and hold the
answer/end button for approximately 5 seconds until the LED has a
constant light. Keep holding down the button until light is constant.
