Intel Desktop Board D510MO Product Guide
38
Connecting to the Front Panel Header
Before connecting to the front panel header, observe the precautions in "Before You
Begin" on page 23. See Figure 12, F on page 34 for the location of the front panel
header.
Table 12 shows the pin assignments for th
e front panel header.
Table 12. Front Panel Header Signal Names
Pin Signal In/Out Description Pin
Signal In/Out Description
Hard Drive Activity LED Power LED
1 HD_PWR Out
Hard disk LED pull-
up (330 Ω) to +5 V
2 HDR_BLNK_GRN Out
Front panel
green LED
3 HDA# Out
Hard disk active
LED
4 HDR_BLNK_YEL Out
Front panel
yellow LED
Reset Switch On/Off Switch
5 Ground Ground 6 SWITCH_ON# In Power switch
7 FP_RESET# In Reset switch 8 Ground Ground
Power Not Connected
9 +5 V Power 10 N/C No pin
Connecting to the Front Panel USB 2.0 Headers
Before connecting to the USB 2.0 headers, observe the precautions in "Before You
Begin" on page 23. See Figure 12, G and H on page 34 for the location of the USB 2.0
headers. Table 13 and Table 14 show the pin assignments for the
headers.
The brown
USB header (Figure 12, G) supports a single USB port while the black USB
header (Fig
ure 12, H) supports two USB ports. The single USB port he
ader is designed
to support a Flash Memory Drive such as the Intel Z-U130 USB Solid-State Drive (or
compatible device). Refer to Installing an Intel
®
Z-U130 USB Solid-State Drive (or
Compatible Device) on page 33 for more information.
Table 13.
Front Panel USB Header
Pin Signal Name Pin Signal Name
1
+5 VDC
2
+5 VDC
3
D-
4
D-
5
D+
6
D+
7
Ground
8
Ground
9
KEY (no pin)
10
No Connect
