■ Memory bank selection
The receiver has 400 memory channels in 8 banks (A–H) for
storage of often-used frequencies.
q Select memory mode with [V/M].
w Rotate [DIAL] while pushing [FUNC] to select the desired
memory banks.
e Rotate [DIAL] to select the desired memory channel.
■ Memory clear
Unwanted memory channels can be cleared (erased). Before
clearing a memory channel, make sure it is no longer needed
as cleared memories cannot be recalled.
q Select memory mode with [V/M].
w Set the memory channel to be cleared with [DIAL].
•Rotate [DIAL] while pushing [FUNC] to select a memory bank
(A–H) or programmed scan edge channel.
e Select VFO mode with [V/M] and push [V/M] for 1 sec. to
indicate the selected memory channel.
•Do not hold [V/M] for more than 2 sec., otherwise the selected
memory channel will be overwritten.
r Push [FUNC] + [V/M] for 2 sec. to clear.
•3 beeps sound, then the frequency is cleared.
t Push [MODE] to return to VFO mode.
