Hunter Fan 45005-01 Manual

next previous

45005-01•11/08/07•HunterFanCompany

You can assemble your fan for standard or angled mounting as shown

in steps 3-1 – 3-3. For low proﬁlemounting(ceilingslessthan8feet

high), go to steps 3-6 – 3-9 on the next page.

3-1. To assemble fan to hang down from a ﬂat or angled ceiling, place

the canopy and canopy trim ring around the adapter so that they

rest on the fan assembly.

3-2. Feed the wires from the fan through the downrod.

Note: Make sure all the wires are on the same side of the metal

dowel pin inside the dowrod.

3-3. Loosen the square head set screw on the adapter to install the

pipe and ball assembly. Note: When the pipe and ball assembly

is fully installed, 2-3 threads on the pipe will still be visible; this is

normal. Securely retighten the set screw with a wrench or pliers.

CAUTION: e adapter has a special coating on the threads. Do

not remove this coating; the coating prevents the downrod from

unscrewing.Onceassembled,donotremovethedownrod.

WARNING: Do not carry or lift fan by canopy.

3-4.Raisethefanandplacetheballintothehangerbracket.

3-5. Alignthenotchontheballwiththeindentinthehangerbracket.

(Rotatethefanuntilyouhearthenotchpopintoplace.)

  Goto4 • Wiring the Fan.

WARNING: Fan may fall if not assembled as directed in these

installation instructions.

Steps 3-4 – 3-5

Indent

Steps 3-1 – 3-3

Downrod

Canopy

(with Washer)

Canopy

Trim

Ring

Set Screw

Adapter

3 • Assembling and Hanging the Fan