7 - 10
5. Finally, set up the ISBN check digit, which is a special position-weighted modulo 11 checksum. The
imager automatically invokes the ISBN checksum for template rows that are:
1.) at least fourteen characters long,
2.) whose first four characters are the letters “ISBN,”
3.) whose last character is a check character, and
4.) when the modulo 11 check character “0123456789X” is programmed.
Please note that all these commands can be combined into a single serial programming command:
OCRENA2,TMP”ISBNggggggggggggctCdddd hdddEtCdddd
hddddE”,GPG”0123456789-”,GPH”P\”,CHK”0123456789X”.
These commands can be encoded into the following Aztec Code symbol:
OCR Template Codes
Note: Reading more than three rows of OCR is not recommended. Contact the factory if you have an
application that requires reading four or more rows of OCR.
† One or more two-digit numbers and Save are required after reading this programming symbol. Refer to the Programming Chart
on the inside the back cover of this manual.
Exit Selections
Enter OCR Template †
Enter User-Defined
Variable “h”
†
Enter User-Defined
Variable “g”
†
Save OCR Template
Discard OCR Template
