12
ENGLISH
INSTALLATION INSTRUCTIONS (continued)
Loading Batteries
(1) Open the battery cover.
Slide the battery cover towards the arrow mark while pressing it.
(2) Load batteries.
Load two Size AA batteries included observing the correct polarities.
When replacing the batteries, always use the R6P AA (or SUM-3) type.
(3) Close the battery cover.
Slide back the battery cover towards the arrow mark.
CAUTIONS
Do not drop or impact the remote controller.
Do not splash the remote controller with water or put it on a wet object
to avoid possible failures.
Before leaving the remote controller out of use for an extended period
of time, remove the batteries from it.
If the remote controller begins to lack responsiveness, replace the
batteries.
Strong light such as direct sunlight impinging on the photoreceptor of
the remote control can cause operational failure. Position this unit to
avoid direct contact with such light.
Do not use batteries of any kind not recommended for this product. Do
not use new and old batteries together. The batteries could explode or
leak, resulting in fires, physical injury, or stains.
When loading batteries, observe their correct polarities as marked on
the product. If loaded in the wrong direction, the batteries could
explode or leak, resulting in fires, physical injury, or stains.
TIPS
Handling the Remote Controller
Use the remote controller within about 5 m from front of the unit’s
remote-control sensor and within 30 degrees on both sides.
