CLI commands
switch port
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
switch port <name>
Switch to the ethernet port context.
syslog
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
syslog
Switch to syslog context.
sensor server name
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
sensor server name <name>
Sets the IP address or hostname of the the RF Manager Server to connect to.
Parameters
Name Specify the IP address of the the RF Manager Server or its hostname. If a
hostname is specified, the service controller must be able to resolve it via
DNS, that is, an entry must be created on the network DNS server that
points to the IP address of the RF Manager Server.
sensor server id
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
sensor server id <id>
Sets the server ID of the the RF Manager Server to connect to.
Parameters
ID Specify the Server ID of the RF Manager Server to connect to. Set the
Server ID to 0 to have the service controller send a discovery request to all
active RF Manager Servers. The service controller will connect to the first
server that responds to the discovery request.
sensor discovery mode
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
sensor discovery mode (id | ip)
Sets the method the service controller will use to communicate with the RF Manager Server.
Parameters
id Connect using the Server ID of the RF Manager Server.
ip Connect using the IP address or hostname of the RF Manager Server.
Description
For these methods to work, the following must be true:
The service controller must be able to reach the RF Manager Server via a network connected
to port 1 or port 2. For example, you should be able to ping the RF Manager Server IP address
from the service controller.
2-135
