35
Release Notes for 07.8.04 Software Fixes
54251 The debug 802.1w all_802_1W_events vlan
command does not send output to a console,
Telnet, or SSH session.
802.1d, CLI 07.8.00 07.8.01d
54375 A Data Access Exception crash occurs when you
enter the no untagged ethernet 21 ethernet 22
ethernet 23 ethernet 24 command after you enter
the qos-tos trust dscp command.
DSCP, QOS 07.8.00 07.8.01d
54527 The debug ip ssh command supports “level 0” as a
valid value.
CLI, SSH 07.8.00 07.8.01d
54542 When deleting a group VLAN, if you enter the no
topology-group 1 or no vlan-group 1 command to
delete the virtual group router-interface, the route is
not deleted from the routing table.
CLI 07.8.00 07.8.01d
54572 During an SSH connection attempt, the routing
switch reloaded and displayed the message:
TRAP REASON - External Interrupt
SSH 07.8.01 07.8.01d
55039 The OSPF age value in a link-state (LS) update or
Data description packet may get corrupted.
For example, the configured OSPF link-state
advertisement (LSA) age is 19218 on two routing
switches. This setting causes the switches to send
LSA updates to each other every second. These
LSAs cannot be aged out.
OSPF 07.8.01 07.8.01d
55290 The de buffers command causes display buffer
leak. The “INFO: all 11 display buffers are busy”
message is displayed in show command output.
CLI 07.8.00 07.8.01d
07.8.02
31281 When you unlock a locked Gigabit Ethernet port,
the DMA chip may be initialized incorrectly, resulting
in a Data Access Exception.
ACL 07.8.02
31779 On an EP 16-Port 10/1000-T module, reconfiguring
the port speed to 1000-F or 1000-M prevents the
routing switch from communicating with a server.
Auto-
negotiation
07.8.02
32534 A routing switch rejects a 2-Port 10 Gigabit Ethernet
module when the module is inserted after the switch
reboots.
System 07.8.02
32541 The hot swapping of a a 2-Port 10 Gigabit Ethernet
module or its Xenpak modules causes the DMA
CAM entries to be deleted.
System 07.8.02
34508 When you enter the no cpupro-action hardware-
flooding enable command, the switch takes an
excessively long time to delete the CAM entries,
causing a system reload.
Other 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
