HP Designjet 70/110plus Printer series—Quick Reference Guide
15
Roll paper can be used only if you have the roll feed accessory.
Note that only one source of paper can be used by the printer at any time. So if a
roll of paper is loaded in the printer and you want to print to a sheet of paper, you
must first unload the roll. If subsequent jobs require a roll to be used, the roll must
be loaded again before they can be printed.
You can cut a roll without unloading it by pressing the OK key; the paper first
advances about 1 cm.
1. Set your application to pick paper from the roll feed.
2. Select Print from your application.
3. Load a roll of the required paper onto the spindle. Make sure that the roll is
turned the right way with the surface on which you wish to print facing up and
that the blue stop on the spindle is pushed in against the paper.
4. Insert the spindle into its retaining slots, with the blue stop on the right (A) and
the black stop on the left (B), as seen from the rear of the printer.
If the paper is glossy, we recommend that you wear gloves to avoid smearing
the surface of the paper.
5. Make sure that the leading edge of the roll is straight and perpendicular to its
side edges.
How do I load a roll of paper? (70)
