Configuration Commands
146
IP Forwarding configuration
The following table describes the IP Forwarding Configuration commands.
Table 124 IP Forwarding Configuration commands
Command Description
[no] ip routing direct-broadcasts
Enables or disables forwarding directed broadcasts. This
command is disabled by default.
Command mode: Global configuration
ip routing
Enables IP forwarding (routing) on the switch.
Command mode: Global configuration
no ip routing
Disables IP forwarding (routing) on the switch. Forwarding is
turned off by default.
Command mode: Global configuration
show ip routing
Displays the current IP forwarding settings.
Command mode: All except User EXEC
Network Filter configuration
The following table describes the Network Filter Configuration commands.
Table 125 Network Filter Configuration commands
Command Description
ip match-address <1-256> <IP address>
<IP netmask>
Sets the starting IP address the IP subnet mask for this filter.
The default address is 0.0.0.0.
This command defines the range of IP addresses that will be
accepted by the peer when the filter is enabled.
Command mode: Global configuration
ip match-address <1-256> enable
Enables the Network Filter configuration.
Command mode: Global configuration
no ip match-address <1-256> enable
Disables the Network Filter configuration.
Command mode: Global configuration
no ip match-address <1-256>
Deletes the Network Filter configuration.
Command mode: Global configuration
show ip match-address [<1-256>]
Displays the current the Network Filter configuration.
Command mode: All except User EXEC
