BdYZa<%+.-B[\#h^cXZ&%$%.
"'&"
2. GZ"Zc\V\Zi]ZiddagZhiWVhZadX`]VcYaZid
hZXjgZi]ZiddagZhiVhhZbWan^cedh^i^dc#
Note: The large clamping hex nut underneath
the tool rest base will require occasional
adjusting to ensure proper clamping pressure
of the tool rest assembly to the bed. Turn this
hex nut in small increments to fine tune the
clamping pressure as needed.
To adjust the angle or height of the tool rest:
1. AddhZci]ZiddagZhiadX` ]VcYaZVcY VY_jhi
i]ZVc\aZdg]Z^\]id[i]ZiddagZhi#
2. Edh^i^dci]ZiddagZhiVeegdm^bViZan
&
¿)VlVn
[gdb i]Z ldg`e^ZXZ VcY Veegdm^bViZan
&
¿-
VWdkZi]Zldg`e^ZXZXZciZga^cZhZZFigure
21#
Adjusting Tool Rest
I]ZiddagZhiWVhZ^hZfj^eeZYl^i]VXVb"VXi^dc
XaVbe^c\ hnhiZb id hZXjgZ ^i id i]Z aVi]Z WZY#
L]Zci]ZiddagZhiWVhZadX`]VcYaZ^hi^\]iZcZY!
VadX`^c\eaViZa^[ihjeVcYhZXjgZhi]ZiddagZhi
VhhZbWan id i]ZWZY# I]Z iddagZhi XVcVahd WZ
edh^i^dcZY VcY adX`ZY Vi V heZX^[^X Vc\aZ dg
]Z^\]i#
To position the tool rest assembly along the
length of the lathe bed:
1. AddhZc i]Z idda gZhi WVhZ adX` ]VcYaZ VcY
bdkZ i]Zidda gZhiVhhZbWan id i]ZYZh^gZY
edh^i^dcdci]ZaVi]ZWZYhZZFigure 20#
Figure 20.IddagZhiXdcigdah#
Always operate the lathe with the tool
rest assembly firmly locked in position.
Otherwise, serious personal injury may
occur.
3. GZ"i^\]iZci]ZiddagZhiadX`]VcYaZidhZXjgZ
i]ZiddagZhi^cedh^i^dc#
Ldg`e^ZXZ
8ZciZgA^cZ
9^hiVcXZh
IddaGZhi
&
¿-
&
¿)
Figure 21.IddagZhiedh^i^dcgZaVi^kZid
ldg`e^ZXZ#
IddaGZhi
IddaGZhi
AdX`=VcYaZ
IddaGZhi7VhZAdX`=VcYaZ
