Page 7SKU 65044
66164
For technical questions, please call 1-800-444-3353.
1. This tool is intended for use on a
circuit that has an outlet that looks
like the one illustrated above in 250
V~ 3-Prong Plug and Outlet. The
tool has a grounding plug that looks
like the plug illustrated above in 250
V~ 3-Prong Plug and Outlet. Make
sure the tool is connected to an outlet
having the same conguration as
the plug. No adapter is available or
should be used with this tool. If the
tool must be reconnected for use
on a different type of electric circuit,
the reconnection should be made by
qualied service personnel; and after
reconnection, the tool should comply
with all local codes and ordinances.
The 250 V~ plug does not come pre-2.
installed and will need to be installed
by a certied electrician.
The plug above is for use on a 15 A 3.
circuit. A different 250 V~ plug and
outlet combination may be used, pro-
vided it is rated to handle the electri-
cal requirements of the tool and is
installed by a certied electrician.
125 V~ REWIRING
Only a qualied electrician should 1.
rewire this lathe to operate on 125 V~
power.
Refer to Wiring Diagrams at end of 2.
manual.
