Install Screws and Bolts:
• Have someone hold the wall bracket centered
in place with each of the holes aligned with
the correct opening in the bracket and level
with the horizontal line.
• Insert the lag screws through the bracket
and into the stud. Tighten with a wrench.
• Insert the bolts into the toggle by hand until snug.
Tighten with a wrench.
STEP 4 INSTALL ANTI-TIP BRACKET
(cont.)
Install Wall Toggles:
The wall toggles and bolts can be ordered as Service
Kit #WR49X10193. Wall toggles are installed in the
drywall and metal studs for stability. Install the wall
toggles as follows:
• Drill 1/2" holes at the wall markings made in the holes
at the ends of the wall bracket.
• Hold the metal channel flat against the plastic straps
and slide the channel through the hole.
• Gently pull back at the ends of the plastic straps
to make the channel rest flush behind the wall.
• Hold the ends of the straps in one hand and slide
the plastic cap along the straps until the flange
of the cap is flush with the wall.
• Place your thumb between the plastic straps and
bend up and down to snap the straps off at the wall.
Installation Instructions
13
