Appendix A Racks
A.1 Rack Mounting
35
Appendix A Racks
This appendix provides various information on the mounting racks for the PRIMEQUEST 2000 series and
PCI_Box.
A.1 Rack Mounting
The PRIMEQUEST 2000 series (including peripheral devices) has been developed and its operation
guaranteed with the basic assumption that it is mounted in a Fujitsu rack. For safe use of a unit mounted in a
Fujitsu rack, contact the distributor where you purchased your product, or your sales representative.
When mounting the PRIMEQUEST products in a rack manufactured by another company, customers need
to confirm on their own responsibility that the rack meets the PRIMEQUEST product specifications and
requirements.
See A.2.2 Requirements for mounting in a rack manufactured by another company.
A.2 Rack Mounting Requirements
This section describes rack mounting requirements.
A.2.1 Requirements for mounting in a Fujitsu 19-inch rack
This section explains the requirements for mounting in a Fujitsu 19-inch rack. For safe use of the
PRIMEQUEST 2000 series server mounted in a Fujitsu 19-inch rack, observe the mounting requirements
described below.
Recommended racks for mounting
The following table lists the recommended racks for mounting the PRIMEQUEST 2000 series server and
PCI_Box.
TABLE A.1 Recommended racks for mounting
TABLE A.2 PRIMEQUEST 2000 series external dimensions
Note
The Fujitsu 19-inch rack comes with a blank panel covering the front of each empty space that has no
mounted device.
If warm exhaust air from the device circulates to the front of the rack and reenters the device, it may cause a
temperature alarm and lead to a device failure.
Be sure to use the blank panel to cover the front of an empty space that has no mounted device.
