80
Saving and Loading Song Data
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DIGITAL
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
REMAIN
SMH
DIGITAL
7. Press the EXECUTE/YES key again.
[Play DAT !] appears on the display.
8. Start playing the DAT machine.
When the saved pilot signal is played, the load operation
starts automatically. The duration for the load operation
appears as a negative value and increments as the opera
tion progresses. The tracks being loaded also appear on
the display.
During the load operation, the LEDs of the RECORD TRK
select keys 1/L and 2/R flash, and the level meters for
tracks 1 and 2, and L and R reflect the levels.
This area indicates a negative value of
the total duration required to load data,
which counts up as the load operation
progresses.
This area indicates the tracks of
currently-loaded data. In this ex-
ample, tracks 1 and 2 are being
loaded. This will change to 3 and 4,
then 5 and 6.
You can monitor the data using the following methods:
• Using the monitor selector [MON]
• Turning the MON knobs for channels 1 and 2 toward [TRK 1] and
[TRK 2] respectively
• Turning the MASTER knob in the monitor section
When the save operation is complete, [COMPLETED !] lights
up on the display, and FD-4 stops. Stop playing the DAT
machine.
9. Press the STOP button or the EXIT/NO key.
[COMPLETED !] disappears, the Program for the data you
loaded is selected, and the ABS Time Base appears.
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
SURE ?
DIGITAL
