Fluke 123/124
Users Manual
36
The readout shows the voltage difference between the
two cursors and the voltages at the cursors in relation to
the zero icon (-). See Figure 1-19).
Use horizontal cursors to measure the amplitude, high
and low value, or overshoot of a waveform.
Using Vertical Cursors on a Waveform
To use the cursors for a time measurement, do the
following:
From Scope mode, display the
Cursor Key functions.
Press to highlight . Observe
that two vertical cursors are
displayed. Markers (-) identify the
point where the cursors cross the
waveform.
If necessary, choose the trace A
or B.
Highlight the left cursor.
Move the left cursor to the
desired position on the waveform.
⑥ Highlight the right cursor.
⑦ Move the right cursor to the
desired position on the waveform.
Figure 1-20. Time Measurement with Cursors
