Ä
Pull the cable(s).
1. Pull the cables to the receiver.
a. Pull the communication/power Ethernet cable through
the receiver’s base, along with any other cables that will
be attached to the receiver (RS-232, Ethernet cable to a
secondary receiver, etc.)
b. If mounting to a wall and using a raceway, place the
cables in the raceway and replace the raceway cover.
2. Connect the cables to the receiver.
a. Connect the Ethernet cable to the Receiver Out port (the
RJ-45 connector on the left on the receiver base).
Å
Place the cables in the raceway and
replace the raceway cover.
Ç
Connect the Ethernet cable to the
Receiver Out RJ-45 jack.
VoiceLift Microphone Installation • Installation — Stage 2
2-10
Installation — Stage 2, cont’d
