SW2 VGAcc and SW2 RGBHVcc • Installation
SW2 VGAcc and SW2 RGBHVcc • Installation
Installation
Through-desk mounting
Both SW2 models can be mounted through a table or podium,
using optional through-desk mounting brackets (Extron part
#70-077-02).
1. Attach the mounting brackets to the switcher with the
screws provided (figure 2-3).
2. Cut the proper sized hole in the mounting surface.
3. Hold the switcher with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4. Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep
in the mounting surface at the marked screw locations.
5. Insert four #8 wood screws through the bracket and into the
four pilot holes. Tighten all four screws to secure the
switcher in place.
Figure 2-3 — Through-desk mounting
Rear Panel Features and Connections
All connectors are on the rear panel. Figure 2-4 shows the rear
panel of the SW2 VGAcc switcher, and figure 2-5 shows the rear
panel of the SW2 RGBHVcc.
Power connection
1
AC power connector — Plug a standard IEC power cord
into this connector to connect the switcher to a 100 to 240
VAC, 50/60 Hz power source.
Figure 2-4 — Rear panel – SW2 VGAcc switcher
Figure 2-5 — Rear panel – SW2 RGBHVcc switcher
Signal input and output connections
2
Computer input connectors:
SW2 VGAcc — Connect your computer input (VGA,
SVGA, XGA, SXGA, UXGA, RGBHV, RGBS, RGsB or
RsGsBs computer video) to the 15-pin HD female
connectors.
SW2 RGBHVcc — Connect your computer input (RGBHV,
RGBS, RGsB, RsGsBs, component video, S-video (Y/C),
and composite video) to the BNC female connectors.
2-4
2-5
50/60 Hz
100-240V 0.2A
SW2 RGBHVcc
OUTPUT
RG
HV
B
INPUTS
R
R
2
1
G
G
B
B
H
H
V
V
12
CONTACT
TALLY
OUT
12
3
2
4
1
INPUTS OUTPUT
1
2
50/60 Hz
100-240V 0.2A
12 12
SW2 VGAcc
CONTACT
TALLY
OUT
3
2
4
1
