Front Panel Features
The controls on the SCP 104/226 replicate the programmed
MLC 104/226 buttons and controls, and most of the System 5 IP
front panel controls. All button functions for the MLCs and the
System 5 IP are configured via RS-232 or Ethernet.
Any action taken at the SCP front panel, such as turning the
knob to increase or decrease volume, pressing a button to turn
the projector on or off, or pressing a button to select an input,
is reflected on the attached MLC or System 5 IP front panel and
vice versa.
NOTE: On the MLCs, the buttons can be programmed to
light bright green, red, or amber when selected; and
the SCP buttons reflect the programming on the
MLC. Buttons that are not selected light dim amber.
On the System 5 IP, only the buttons indicated by
b in the following front panel illustrations and
button #6 in group
c can be programmed to light in
the three colors.
See the Global Configurator help file for instructions on
programming the buttons.
When a button is pressed or the knob is turned on the SCP
front panel, the action is communicated through the RS-232
port. Use a tool such as Extron DataViewer on a computer
that is connected to the RS-232 port on the SCP to view this
information.
You can also issue SIS commands to the SCP to light LEDs and
buttons (see the “Remote Communication” section, beginning
on page 31, for information on SIS commands).
SCP 104 and SCP 226 • Installation and Operation
21
