Operation, cont’d
MGP 464 • Operation
3-18
PRELIMINARY
Making changes to the serial port and IP conguration
To make changes to the serial port conguration, IP address, DHCP mode, Gateway
address, and/or Subnet mask, you must access the edit level screens as follows:
1. With any Comm./IP Conguration menu view-level screen displayed,
press the Enter button and hold it until the Serial Cong screen appears
(approximately 2 seconds).
2. Press Next repeatedly to cycle through the edit level screens.
3. To enter or change information on each screen, rotate the horizontal Adjust
knob (
[
) to move the angle brackets to the desired setting. Rotate the
vertical Adjust knob (
{
) to adjust the setting.
4. When nished editing the settings for the selected item, either press Next to
go to the editing screen for the next item, or press Menu to exit serial/IP edit
mode and go to the next menu (Advanced Configuration).
Screens are provided for editing the following parameters:
• Serial Config: Configure the serial port by switching between RS-232 and
RS-422, and selecting the baud rate.
• Set DHCP Mode: Set DHCP to On or Off.
N
DHCP must be off before you can edit the IP addresses.
• Set IP Address: Set the IP address.
• Set Gateway Addr: Set the gateway address.
• Set Subnet Mask: Set the subnet mask.
N
You cannot edit the MAC address; there is no editing screen for it.
Background Capture
Comm. / IP
Configuration
Menu
Serial Port
RS232 9600
Next
IP Address
010.013.005.130
Next
Set DHCP Mode
<Off>
Next
Rotate either Adjust knob
to adjust the submenus.
Press and
hold the
Enter button
for 2 seconds.
Next
DHCP Mode
Off
Next
Serial Config
<RS232> 9600
Next
Next
MAC Address
0005A600C1A5
Gateway Address
010.013.000.100
NEXT
Set Gateway Addr
<010>.013.000.100
Subnet Mask
255.255.000.000
Set IP Address
<010>.013.005.130
Next
Set Subnet Mask
<255>.255.000.000
Next
Next
Next
Menu
Menu
View level
Edit level
Advanced
Configuration
Communication/IP Configuration menu flow
